Local contractor in 32218

The range breaker continually tripped, leading us to check the electrical panel. We found two damaged 40 amp breakers due to improper installation and replaced them. Upon further inspection, we identified a dead short caused by failing wire connections on the range, which we addressed to restore functionality.

Recognizing the need for an accessible power source, we installed a receptacle at the top of the stairs near the closet for computer use. This included utilizing the adjacent power supply. Upon completion, we verified proper voltage and operation to ensure the installation met electrical standards.

During the inspection, double taps were discovered in the electrical panel, posing a risk to safe operation. We redistributed the wires to eliminate these double taps, specifically removing one from a 60 amp breaker and installing it on an appropriately sized breaker. After completing the adjustments, we verified proper voltage and functionality to ensure safety and reliability in the system.

Installed a new GFCI-protected circuit from the existing power source on the back of the home to the new patio using conduit. Installed weather-resistant receptacles on each rear patio corner and an additional receptacle at the center of the existing wall. Verified proper voltage and operation upon completion.

The damaged outlet supplying power to the sump pump posed a serious issue due to pump failure. We promptly removed the faulty outlet and replaced it with a new GFCI outlet, complete with a new cover, to ensure the sump pump operates safely and reliably moving forward.

To enhance the building's electrical safety and efficiency, we installed surge protection at the main panel and secured the A/C disconnect. Inside the brick building, we connected the main panel to the sub panel, ensuring reliable power distribution throughout the facility. This comprehensive service guarantees optimal electrical performance for all commercial needs.

Use preexisting wire to remodel island in kitchen and add GFCI receptacle for garbage disposal and dishwasher.

Verified the validity of the inspection report and addressed the customer’s concerns by rectifying the following issues: water heater wiring not being protected as well as loose receptacles.

Aluminum wiring can create safety hazards when connected to standard electrical devices. To address this, we removed existing switches and receptacles and installed Alumiconn devices, ensuring secure connections. Additionally, we installed 15 new standard devices and covers to enhance the overall safety and functionality of the electrical system.

The water pump was found to be non-operational due to a failing motor winding. We verified proper incoming power and confirmed 240 volts at the pump house. After diagnosing the fault, we disconnected the booster pump to prevent further damage and ensure system safety pending repair or replacement.